Sunbeam LED Case Handle - RED

Features:
1. Built-in LEDs provide fantastic lighting
2. Comfortable hand grip and attractive look.
3. Double-designed handles promise long lifetime
4. Large area metal washers add stability and strength

Specifications:
- Height: 46.5mm Length: 180mm
- Material: transparent plastic handle,hard anodized steel handle
- Contents: 2 double-designed handles,4 LED lamps,molex(F&M), wires,screws, plastic washers ,nuts

Clear Plastic handle

Installations/Use:

1. First, make two templates according to metal washer, use a sharp pencil to mark the gap of holes and four 4mm-diameter holes on each template,
2. Place templates on the top case panel where you’d like to install handles and drill holes.
3. After your holes are made, start to mount double handles with screws.
4. Insert LED lamps into the second assembled holes from inside case, make sure the LEDs are securely fixed in the plastic handles’ pre-drilled holes,then clip the terminal part of LEDs with plastic washers.It can prevent LEDs from falling down off the holes.
5. Tighten all screws with nuts. Connect the molex connector to your PSU. Then enjoy the mobility and fantastic lighting of your case.